FAST 102 & 92 Steam Vent Kit Complete LS1 LS6 LS3 Coolant Crossover BLK SV102BN

Description

Note... you will not find a nicer set anywhere... on ebay, or any major name brand supplier. Just a fact, not an advertisement. :-) Please read entire description.
LS family of engines -4AN anodized BLACK aluminum Steam Vents with hose & hardware for front and rear venting. Complete kit.
Designed specifically for FAST102 manifolds.
As you may know, FAST intake manifolds have a large plenum and runners. This large capacity causes clearance issues with most aftermarket steam vent kits.
After much ado, finally a kit that will work on the 102's.
This driver front and passenger rear vent ports cause the most fitment issues; this raises issues with installation. Which may result in being required to lift the manifold. We have installed the kit in the shop without the need of lifting the manifold. However it takes patience and a bit of luck.
It is possible you might need to lift the manifold approximately .5" to clear these two corners
. Once you get the AN fittings threaded on the steam vents on the two corners the rest of the kit is a simple install.
Set (4) of LS aluminum 6061 steam vents with precise fitment and high quality engineering Billet vents feature precision machining with Allen head bolts and “O” ring pressure sealing.

Black anodized lightweight 6061 AN aluminum fittings provide maximum flow and do not require sealing compound or Teflon tape, one-piece reusable mandrel-bent fittings.
Includes (All assembled):
Hose 1 Driver side front to driver side rear:
• 45° fitting front (difficult corner) & 90° fitting rear. 21"
Hose 2 Driver rear to passenger side rear:
• 0° fitting driver side rear & 120° fitting passenger rear (difficult corner). 10"
Hose 3 Driver rear to passenger side front:
• 0° fitting driver side rear & 90° fitting passenger front. 31"
Hose 4 Passenger side front to radiator:
• 90° fitting passenger front to -4 hex finisher. 24"
• Two -4AN T-fitting with swivel on run
• One -4AN T-fitting with swivel on side (passenger rear top)
• Four -4AN Steam Vent fitting
-4 black nylon braided hose with bursting strength at 1,500lbs. Already cut to proper length and fittings installed to route all 4 corners into one complete comprehensive kit.
Note:
Some cars may have larger 3/8 barb fittings on their radiators. If so there is one of a few solutions.
1) try like heck to slip the -4 hose over the larger barb with some WD-40
2) stretch the hose overnight and apply some heat
3) buy the -4 to -6 hose adapter hose with fittings located item #141990963697
Installing steam vent reliefs on in all four corners of the engine have been proven to limited detonation in chambers 8 and 7 specifically. A must for high horsepower engines!!!
This is a high quality kit that will flow well and be a great improvement over stock steam vent plumbing. It is a turnkey solution that will take the headache out of your upgrade.
See my other auctions or my website @ FaSSter for other styles and colors for other Gen III and IV engines.
See item: 141331552125